Burning HTTP Server demo with parallel programmer (ISP10)
From Nutwiki
Please read first the official manual because the following is just personal notes
Be sure that you installed ethernut 4.2.1 on your Etch and well configurated it (patchs etc..)
$ vim ~/ethernut-4.2.1/nut/app/Makeburn.avr-dude
Modify :
[...] BURNPORT=/dev/parport0 [...] AVRDUDE_PROGRAMMER = stk200
Load the modules :
# modprobe parport # modprobe ppdev
Verify that the device is here :
$ ls /dev | grep parport ... parport0 ...
Now follow the instructions on the official doc to modify your IP adress etc..
Plug the programmer to your card, switch on and as said on the doc :
$ make clean # make burn
When finished unplug the programmer, switch off your card.
Plug an ethernet link on the card, switch on. Open your browser and see http://*the.ip.you.choosed*/
--jfg 12:04, 15 April 2007 (UTC)