Editconf
From Nutwiki
Revision as of 16:45, 12 October 2012 by Harald (Talk | contribs) (New page: == General Functions == Nut/OS network configurations are typically stored in non-volatile memory. The application editconf can be used to edit the current settings. When started, Someth...)
General Functions
Nut/OS network configurations are typically stored in non-volatile memory. The application editconf can be used to edit the current settings.
When started, Something similar to the following output appears on the console:
Network Configuration Editor - Compiled Oct 12 2012 - 16:33:49 Board : Elektor Internet Radio Memory : AT45D DataFlash Page : Last Size : 528 SPI Base: 0xFFFE0000 Chip : 0 Chip Sel: 0 Configuration loaded
The information about the non-volatile memory on the first few lines differs, depending on the target the board is running on.
The program will then query the essential network interface settings:
MAC Address: 02:00:00:00:00:00 IP Address: 0.0.0.0 IP Mask: 255.255.255.0 IP Gate: 192.0.0.1
You may either edit any configuration (using the backspace key) or simply press enter to confirm the current setting.
Finally press S to save your new configuration or any other key to discard any changes and repeat the query.
Press S to save this configuration
