Difference between revisions of "Elektor Internet Radio"
(→Firmware not running)
m (1 revision imported)
Latest revision as of 18:02, 27 October 2016
Firmware not running
Q: After uploading the firmware, nothing happens. What is wrong?
A: Check the serial port output. After pressing reset, the radio should at least print the firmware version numbers. Further, run the Nut/OS Discoverer to scan the network.
Q: No output at the serial port and no entry in the Nut/OS discoverer. What else can I try?
A: Make sure you set the GPNVM2 flag with SAM-BA or OpenOCD. If not set, the radio will start the bootloader after reset, not the firmware you uploaded into Flash memory.
Q: I did program the GPNVM2 flag with OpenOCD. Why doesn't the firmware run after reset?
You may run an old OpenOCD release. The latest we tested with success was release 520 from April the 1st, 2008.
After setting the GPNVM2 flag you might have to resume the CPU and should shutdown OpenOCD before pressing the reset button.
target state: halted target halted in Thumb state due to debug request, current mode: Supervisor cpsr: 0x000000b3 pc: 0x00200cb4 > flash probe 0 flash 'at91sam7' found at 0x00100000 > flash write_bank 0 webradio-1.2.1.bin 0
> at91sam7 gpnvm 2 set
Q: Why doesn't SAM-BA show the USB connection?
A: You need to erase the firmware to activate the SAM-BA bootloader.
Q: How do I use the Olimex OpenOCD JTAG instead of the Egnite Turtle version
A: you need to change the configuration file of openocd and start with a parameter like this : openocd -f eirocd.cfg
contents of the eirocd.cfg file is
cat eirocd.cfg #daemon configuration telnet_port 4444 gdb_port 3333 daemon_startup reset #interface interface ft2232 ft2232_device_desc "Olimex OpenOCD JTAG" ft2232_layout "olimex-jtag" ft2232_vid_pid 0x15BA 0x0003 jtag_speed 2 #use combined on interfaces or targets that can't set TRST/SRST separately reset_config srst_only # srst_pulls_trst jtag_nsrst_delay 200 jtag_ntrst_delay 200 #jtag scan chain #format L IRC IRCM IDCODE (Length, IR Capture, IR Capture Mask, IDCODE) jtag_device 4 0x1 0xf 0xe #target configuration #target <type> <startup mode> #target arm7tdmi <endianness> <reset mode> <chainpos> <variant> target arm7tdmi little reset_halt 0 arm7tdmi run_and_halt_time 0 30 #flash bank at91sam7 0 0 0 0 <target#> #AT91SAM7 flashes only require the target#, #all other values are looked up after reading the chip-id and type. flash bank at91sam7 0 0 0 0 0