Difference between revisions of "Hardware/EIR/Assembly"
(Created page with "<div id="content"> = Assembly Instructions = {| |width="50%"| [[../../../img/eir_leer.jpg|[[File:../../../img/eir_leer_thumb.jpg]]]] |width="50%"| EIR boards are shipped wit...") |
(No difference)
|
Latest revision as of 10:56, 13 July 2017
Assembly Instructions
[[../../../img/eir_leer.jpg|[[File:../../../img/eir_leer_thumb.jpg]]]] | EIR boards are shipped with SMD parts populated, but THT parts packed seperately for DIY soldering. |
[[../../../img/eir_1-2.jpg|[[File:../../../img/eir_1-2_thumb.jpg]]]] |
1. Ethernet connector Because the firmware had been preloaded, you should be able to receive and listen to Internet radio stations. |
[[../../../img/eir_3-4.jpg|[[File:../../../img/eir_3-4_thumb.jpg]]]] |
In order to be able to erase and the Flash memory and upload new firmware, we need to mount 3. Expansion port connector K3 (or at least pins 34 and 36) |
[[../../../img/eir_5-6.jpg|[[File:../../../img/eir_5-6_thumb.jpg]]]] |
If things are not working as expected, it would be a good idea to make use of the serial port, where the following parts are needed.
|
[[../../../img/eir_7.jpg|[[File:../../../img/eir_7_thumb.jpg]]]] |
In order to use the JTAG interface, mount
|
[[../../../img/eir_8.jpg|[[File:../../../img/eir_8_thumb.jpg]]]] |
For RTC backup during power loss, mount
|
[[../../../img/eir_9.jpg|[[File:../../../img/eir_9_thumb.jpg]]]] |
Finally, if you intend to attach an add-on board, K3 should have been fully populated. Additionally mount
|
[[../../../img/eir.jpg|[[File:../../../img/eir_thumb.jpg]]]] | Finished! |
Return to the EIR project page.